Idro Gas Engineering S.n.c.

"TREPI" Clamp for repairing

Produced from DN 40 mm to DN 800 mm

Clamps for repairing or jointing series TREPI made of three ductile iron (EN-GJS-400-15 acc. to UNI EN 1563 norms) sectors coated with fusion bond epoxy (min. 150 microns), complete with rubber seal gaskets (EPDM or NBR) with a special profile and deep heat-galvanised steel nuts and bolts. The collar provides a permanent seal around the full length and circumference of the pipe covered by the collar

All the clamps are designed to allow installation without needing to turn off or to reduce water pressure in the pipe.


1 Ductile iron sectors	2 Deep heat-galvanized bolts and nuts (Stainless steel as optional)
3 Rubber seal gasket

Optionals

4. Threaded derivation. One of the sector is equipped with a threaded female outlet in accordance with UNI-ISO 228 norms

5 Flanged derivation. One of the sectors is equipped with a flanged outlet in accordance with UNI-ISO PN 10 or PN 16 norms

Assembly and application example (picture)

Technical Data

"TREPI" clamp for repair

"TREPI" clamp with flanged outlet

"TREPI" clamp with threaded outlet

Idro Gas Engineering S.n.c
Via Roma 101
13010 Motta de' Conti (Vc)
Italy
Tel. ++390161780400/780444
Fax. ++390161780909/780411

Photo Album

E-Mail